Cocktail Audio™ UK Support Forum
http://www.cocktailaudio.co.uk/Forum/

X10 optical connect issue
http://www.cocktailaudio.co.uk/Forum/viewtopic.php?f=16&t=1332
Page 1 of 1

Author:  nunhead_man [ Sat Nov 21, 2015 4:34 pm ]
Post subject:  X10 optical connect issue

I've used an optical interconnect from our X10 to our Denon reviever - for convenience to use the same set of speakers.

The Denon reports "signal unlock" which means basically just an indication that a digital signal is detected.

This does not help really as there is no sound when I play a track on the X10

Suggestions team?

Author:  tech1a [ Sun Nov 22, 2015 2:21 pm ]
Post subject:  Re: X10 optical connect issue

I think you have to explain the setup as you are not doing something right...

Typical setup:
Eg: X10 (OUT) ----> Den (IN) => Speakers.
Check port or input switcher on Den is the same as the X10.

Author:  nunhead_man [ Sun Nov 22, 2015 2:45 pm ]
Post subject:  Re: X10 optical connect issue

Hi

Thanks - and RTFM as we say here.

Now fixed in one of the set up menus - speaker turned off etc

If you want an editor to re-edit your instructions in proper Egerlish we have the very person here at reasonable rates :-)

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/